LABCENTER PROTEUS TOOL INFORMATION FILE
=======================================

In case of difficulty, please e-mail support@labcenter.co.uk

Tool set up for Proteus layout 'thin lines printer test.pdsprj'.
CADCAM generated at 15:02:26 on 4  2015 ..

File List
---------
Top Copper              : thin lines printer test - CADCAM Top Copper.TXT
Top Silk Screen         : thin lines printer test - CADCAM Top Silk Screen.TXT
Top Solder Resist       : thin lines printer test - CADCAM Top Solder Resist.TXT
Top SMT Paste Mask      : thin lines printer test - CADCAM Top SMT Paste Mask.TXT
Mechanical 1            : thin lines printer test - CADCAM Mechanical 1.TXT

Photoplotter Setup
------------------
Format: RS274X, ASCII, 2.4, imperial, absolute, eob=*, LZO
Notes:  D=Diameter, S=Side, W=Width, H=Height, C=Chamfer

D10	CIRCLE  D=5th                                                             DRAW
D11	RECT    W=10.6th              H=20.4th                                    FLASH
D12	RECT    W=14.1th              H=20.4th                                    FLASH
D13	RECT    W=20th                H=30th                                      FLASH
D14	RECT    W=100th               H=40th                                      FLASH
D15	RECT    W=30th                H=20th                                      FLASH
D16	CIRCLE  D=2th                                                             DRAW
D17	CIRCLE  D=8th                                                             DRAW
D18	RECT    W=30.6th              H=40.4th                                    FLASH
D19	RECT    W=34.1th              H=40.4th                                    FLASH
D70	RECT    W=40th                H=50th                                      FLASH
D71	RECT    W=120th               H=60th                                      FLASH
D20	RECT    W=50th                H=40th                                      FLASH

NC Drill Setup
--------------
Format: ASCII, 2.4, imperial, absolute, eob=<CR><LF>, no zero suppression.
Notes:  Tool sizes are diameters. Layer sets are in brackets - 0=TOP, 15=BOTTOM, 1-14=INNER.



[END OF FILE]
